Monday 8 June 2015

2-Way Radio Range: How Far Can Two-Way Radios Communicate? Part 2

Two-Way Radio Power

Another important factor in the distance a two-way radio will communicate is its power output. This power output is measured in “watts.” You’ve likely heard an FM radio station say they are broadcasting at 50,000 or 100,000 watts. Well, a handheld business-type two-way radio usually broadcasts at 1-5 watts. A vehicle mobile radio may broadcast anywhere from 5 to 100 watts. The more watts a radio has, the farther it can transmit.

Why is this? When water moves through a pipe it loses pressure along the way. When electricity flows along a wire it loses current. When an object is rolling, it will eventually stop rolling due to friction. Radio waves operate by the same laws of physics as everything else so there will be signal loss along the way. B
ut if you apply more water pressure, more electrical current, or get the rolling object moving faster, you'll get more distance out of all of them. The same is true for a radio signal. Increasing the power in watts at the source helps overcome any "resistance" along the way.

Keep in mind that for battery-powered handheld radios more watts is not always a good thing. The higher the wattage, the quicker your batteries run down.

Radio Frequencies

One more factor in determining how far a two-way radio will communicate is the frequency it uses and the environment that frequency is used in.

There are two major formats for most two-way radios.  They are Ultra High Frequency (UHF) radio and Very High Frequency (VHF) radio. Neither frequency band is inherently better than the other.  They each have their pluses and minuses. Both formats are effective ways to communicate with another person so deciding on the right radio for you depends on your application.

Two-way radios communicate with each other through use of radio waves. Radio waves have different frequencies, and by tuning a radio receiver to a specific frequency you can pick up a specific signal.

Radio waves are transmitted as a series of cycles, one after the other. You will always see the “Hz” abbreviation used to indicate the frequency of a radio. Hertz is equal to one cycle per second.


Radio waves are measured by kilohertz  (kHz), which is equal to 1000 cycles per second, or megahertz (MHz), which is equal to 1,000,000 cycles per second--or 1000 kHz. The relationship between these units is like this: 1,000,000 Hertz = 1000 kilohertz = 1 megahertz.


You may also hear the term “wavelength” when you hear about radio waves. This term is from the early days of radio when frequencies were measured in terms of the distance between the peaks of two consecutive cycles of a radio wave instead of the number of cycles per second. Lower frequencies produce a longer wavelength (the width of each cycle gets bigger on lower frequencies).

What is significant about wavelength for two-way radios is that it affects transmission range under certain conditions. A longer wavelength, which corresponds to a lower frequency, as a general rule lets a radio signal travel a greater distance.

Lower frequencies or longer wavelengths also have greater penetrating power. That’s one of the reasons they are used for communicating with submarines. VLF (Very Low Frequency) radio waves (3–30 kHz) are used to penetrate sea water to a depth of approximately 20 meters. So a submarine at shallow depth can use these frequencies.

So from what you read above you may think VHF is always the better choice for a two-way radio no matter where you are using it since it has a lower frequency than UHF and the signal can travel a greater distance. That’s not necessarily true. Even though VHF has better penetrating capabilities and can travel farther, that doesn’t necessarily make it the better choice for use in buildings. Remember the conversation about wavelength above?  Wavelength has a big impact on transmission distance.

1 comment:

  1. Thanks for sharing your great info regarding 2 way radio range. Digital Two Way Radio helps increase the mobile work team efficiency.

    Digital two way radios

    ReplyDelete